Why is my furnace running but blowing cold air?
The most common causes are a dirty flame sensor (the burners light, then shut off within seconds), a failed ignitor, a clogged filter that trips the high-limit switch, or a thermostat set to "fan on" instead of "auto." A dirty flame sensor is a quick, inexpensive fix; a cracked heat exchanger is not, and it's a carbon monoxide risk — if the furnace keeps shutting down, call rather than keep restarting it.
How much does furnace repair cost in Joliet?
Most furnace repairs in the Joliet area land between $150 and $900 depending on the part. Flame sensors, ignitors and capacitors are on the low end; blower motors and control boards on the high end. We quote a flat rate in writing after the diagnostic, and the diagnostic fee is waived when you approve the repair.
Should I repair or replace my furnace or AC?
A useful rule: multiply the repair cost by the system's age in years. If the result is over $5,000 — say a $600 repair on a 10-year-old unit — replacement usually wins, especially with current ComEd and Nicor efficiency rebates. Under that, repair. We'll run the numbers with you either way and won't push replacement when a repair is the smarter spend.
Why is my AC running constantly but the house won't cool?
Usually low refrigerant from a leak, a frozen evaporator coil (often from a dirty filter or low airflow), a failing capacitor that keeps the compressor from starting properly, or a unit that was undersized for the house. On 90° Joliet days a healthy system should hold the thermostat setting; if it can't, something is wrong and it's costing you on the ComEd bill.
Do you offer emergency furnace and AC repair at night and on weekends?
Yes — 24 hours a day, 7 days a week, including holidays. No-heat calls in winter are treated as emergencies. There is a modest after-hours premium, quoted up front when you call.
How often should a furnace be serviced?
Once a year, ideally in early fall before the first cold snap. An annual tune-up keeps the manufacturer's warranty valid, catches worn parts before they fail, and includes a carbon monoxide safety test. Air conditioners get the same treatment each spring.
Do you need a permit for a new furnace or AC in Joliet?
Yes. The City of Joliet requires a mechanical permit for furnace, boiler and air-conditioner replacement, and the work must be done by a contractor registered with the city. We pull the permit and schedule the inspection as part of every installation.